YES and NO in Morse Code
YES spans 25 timing units (1.50 s at 20 WPM) and NO spans 19 timing units (1.14 s at 20 WPM). Play or copy either word below, then compare the single-letter replies used on CW radio.
YES -.-- . ...
Speed and pitch follow your shared MorseAtlas settings (currently 20 WPM, 600 Hz).
NO -. ---
Speed and pitch follow your shared MorseAtlas settings (currently 20 WPM, 600 Hz).
How are YES and NO written character by character?
YES (-.-- . ...) has 3 letters, 8 marks, and 25 timing units — taking 1.50 s at 20 WPM (25 × 60 ms). NO (-. ---) has 2 letters, 5 marks, and 19 timing units — taking 1.14 s at 20 WPM (19 × 60 ms).
YES
25 timing units · 1.50 s @ 20 WPM- Y-.--long-short-long-long (dah-di-dah-dah)
- E.one short (dit)
- S...three short (di-di-dit)
NO
19 timing units · 1.14 s @ 20 WPM- N-.long-short (dah-dit)
- O---three long (dah-dah-dah)
What single-letter CW shorthand replaces YES and NO?
In real CW radio traffic, spelling out YES takes 25 units when a single letter (C for affirmative or N for negative) answers clearly through noise. Tap any card to load and play it in the translator.
C
-.-.Affirmative (“Yes”). Standard ITU CW reply to a question, derived from Spanish “sí”.
N
-.Negative (“No”). Single-letter CW reply when declining or answering no.
R
.-.Roger / Received. Means “I copied your message solidly” (not an answer to yes/no).
K
-.-Invitation to transmit (“Go ahead / Over”) at the end of a turn.
Why doesn't one tap mean YES and two mean NO in Morse code?
One tap or blink for “yes” and two for “no” is an informal movie or diving cue rather than International Morse. In Morse code, one dot (.) is the letter E and two dots (..) are the letter I, so receivers only read them as YES/NO if both people agreed on that private shortcut beforehand.
Whenever someone is decoding standard ITU Morse — by ear, via the alphabet chart, or with the audio decoder — send full -.-- . ... / -. ---, or use CW C (-.-.) and N (-.). You can also render practice WAV clips in the audio generator.
Frequently asked questions
What are YES and NO in Morse code?
YES is -.-- . ... (3 letters, 8 marks, 25 timing units — 1.50 seconds at 20 WPM) and NO is -. --- (2 letters, 5 marks, 19 timing units — 1.14 seconds at 20 WPM).
Why do CW operators send C or R instead of spelling YES?
In radio CW traffic, single letters save airtime and read reliably through static: C (-.-.) means affirmative ("yes"), N (-.) means negative ("no"), and R (.-.) means "Roger / message received" rather than answering a yes-or-no question.
Does one tap or blink mean YES and two mean NO in Morse code?
No — that is an informal movie or dive convention, not International Morse. In Morse code, one dot (.) is the letter E and two dots (..) is the letter I, so send full YES/NO or CW shorthand C/N unless both parties agreed on a custom tap signal.
What does K (-.-) mean on Morse code radio?
Sent at the end of a transmission, K (-.-) means "Over / Invitation to transmit" — telling the other station to go ahead and reply.